The Promag programmer
The handheld programmer enables the user to change all parameters concerned and can be
used with all Processautomatics magnetic flowmeters regardless of model. This is very useful when a standard setting of an output needs to be changed on site, or the calibration factor needs to be adjusted of after a field calibration.
The handheld programmer provides access to all parameters connected with the outputs of the Magnetic Flow Meter. The handheld programmer consists of a four digit display and four buttons. When connected and powered up, the display shows the content of an EEPROM memory chip in the Magnetic Flow Meter. This EEPROM consists of 32 2 digit registers (memory locations), and the values of the registers controls all parameters concerning outputs, size of the Magnetic Flow Meter and calibration.